10 Upton Drive, Wilmington, MA 01887
Toll Free 800-657-7704
Laboratory Air HandlingWater TreatmentMarine Architectural Lighting Design Home

 

 

Lighting Design
Learn More
   
  Architectural
Learn More
 

 

Marine
Learn More
 

 

Water Treatment
Learn More
 
  Air Handling
Learn More
 
  Laboratory
Learn More

Boat and RV Tanks

Machined Fittings
HDPE Couplings
HDPE Half Couplings
HDPE Flanges With Weld Stubs
Boat and RV Tanks
Graduated Cylinders
Industrial Rectangular Tanks
Lexan Water Baths

PolyFab boat and RV tanks are fabricated with the care you expect for a premium product. We manufacture water and waste tanks only. Our preferred material is natural polypropylene, but we fabricate polyethylene and PVC tanks on request. NPT couplings on the sides and top are normally mounted flush on the outside with a machined shoulder on the inside. The fittings are welded inside and out. We have never experienced a fitting “blow out”. Bottom fittings are installed flush on the inside for full drainage. Internal baffles are normally used when one of the dimensions is greater than 30 inches. These are welded all around, including to the top. We accomplish this by slotting the cover to accept a tab on the baffle. The top of the baffle is welded from the outside.

We also install cleanouts as required. The most common design is a 1 inch thick ring with a 4.5 inch ID and a 7 inch OD welded to the inside of the cover around a 6” dia hole. The cover is gasketed and held down with 6 flat head screws. If you want another design, just fax us a sketch.